Powermatic PM1300 Manuale Utente

Instructions and Parts Manual PM1300 Dust Collector PM1300 with Filter Bag Kit (1791077BK) PM1300 with Canister Kit (17910

10Filter Bag System Assembly Note: If your dust collection system includes the canister kit, proceed to Canister System Assembly on page 11. 1. Inser

11Canister System Assembly (17mm wrench required) 9. Place the snap ring over the top of the plastic collector bag, and fold over the bag approximate

12Electrical Connections Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be

13Operating the Machine Connect the dust collector to the power source. If power is flowing, a green indicator will light on the face of the control

14Cleaning the Canister Filter Clean the canister filter frequently to keep the collector's performance at its optimum. To clean the filter, tur

15Replacement Parts Replacement Parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848, Monday

16Parts List for PM1300 Dust Collector (Base Machine) Index No. Part No. Description Size Qty 1 ... PM1300-101...Impeller Ho

1743 ... TS-155010 ...Flat Washer...M16 ... 1 44 ...

18Breakdown for PM1300 Canister Filter System

19Parts List for PM1300 Canister Filter System Index No. Part No. Description Size Qty ... 1791086 ...Canister Assemb

2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au

20Parts List for PM1300 Filter Bag System Index No. Part No. Description Size Qty ... 1791077B...PM1300 Collection and

21 Electrical Connections

22NOTES

23

24 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-

3 Table of Contents Warranty and Service...

4 Warning 1. Read and understand the entire owner’s manual before attempting assembly or operation. 2. Read and understand the warnings posted on

5 20. Make your workshop child proof with padlocks, master switches or by removing starter keys. 21. Give your work undivided attention. Looking ar

6 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a Powermatic

7 Unpacking Remove all contents from the shipping carton and check against the Contents of Shipping Carton below to verify that all items have been r

Base Machine Assembly The dust collector must not be connected to the power source during assembly. Failure to comply may result in serious injury! A

9 Handles 1. Remove the plate (V) from the handle (U) by loosening the two socket head cap screws (W) with a 6mm hex wrench. 2. Install handle (U) t